Skip to content
CutToolExplore the journal
Home / Specifications

Insights & perspectives

A specification checklist for cutting tools

·
Editorial illustration accompanying the CutTool article library

A specification for cutting tools is easier to compare when each field has a clear label and an identifiable source. The checklist below is a structure for recording information; it does not replace the applicable product or project documents.

Identify the record

  • Tool identification and intended work
  • Manufacturer documentation and revision
  • Inspection observations and the date of review

Keep comparisons consistent

Use the same field names when comparing two records. Preserve units, revision dates and the conditions attached to a reported value. Leave an unanswered field visibly open instead of filling it with an assumption.

Check the source beside each value

Record where a detail came from and whether it is a supplier statement, a drawing requirement or a project observation. A short source label makes it possible to return to the original document when the record is reviewed.

Finish with an open-question list

  1. Mark fields whose source has not been confirmed.
  2. Identify differences in scope or measurement conditions.
  3. Record the person or document needed for the next review.

A complete comparison should show both the recorded information and the remaining limits of the comparison.